Graco 24C728 Instructions - Parts Manual

Graco 24C728 Instructions - Parts Manual

Series b expanding blade mixer

Advertisement

Instructions/Parts
AIR DRIVEN
Expanding Blade Mixer
Expanding blade bung-mounted agitator for maintaining suspension and even mixing in
industrial paints and coatings. For professional use only.
Not approved for use in European explosive atmosphere locations.
Model 24C728, Series B
Low Viscosity, up to 1000 centipoise
Model 24C729, Series B
High Viscosity, up to 2000 centipoise
100 psi (0.7 MPa, 7 bar) Maximum Working Pressure
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
Contents
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Repair . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Technical Data . . . . . . . . . . . . . . . . . . . . . . . . .10
Graco Standard Warranty . . . . . . . . . . . . . . . .12
Graco Information . . . . . . . . . . . . . . . . . . . . . .12
313643F
ENG
ti14646A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 24C728 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Graco 24C728

  • Page 1: Table Of Contents

    Graco Standard Warranty ....12 Graco Information ..... .12...
  • Page 2: Warnings

    Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama- tion point symbol alerts you to a general warning and the hazard symbol refers to procedure-specific risk. Refer back to these warnings. Additional, product-specific warnings may be found throughout the body of this manual where applicable.
  • Page 3 Warnings 313643F...
  • Page 4: Installation

    Connect ground clamp to a true earth ground. A ground minute for high speed or continuous duty usage. Do not wire and clamp, Part 238909, is available from Graco. overfeed oil or exhaust air may become contaminated. To manually lubricate the air motor, see Lubricate the Air Motor, page 6.
  • Page 5 Installation Install the Agitator NOTICE Keep the agitator tightly mounted to the drum bung to prevent damage to the threads from vibration. When using a modified drum, check that there is no Always maintain a minimum of 1 in. (25.4 mm) clear- interference between the base of the drum and the ance between rotating agitator parts and container to shaft of the agitator to prevent blade or shaft dam-...
  • Page 6: Operation

    NOTE: If an air shutoff valve is installed in the supply line and used to stop the agitator, the same agitator speed will be set each time the agitator is used. Part numbers for Graco air shutoff valves are listed below: Air Shutoff Valve Part...
  • Page 7: Repair

    5. Lubricate the motor with a squirt of lightweight oil in the chamber. NOTE: Air Motor Repair Kits are available. Order Part 207335 for Model 24C728 (low viscosity) or Part 224954 for Model 24C729 (high viscosity). Service Reassembly Air Motor 1.
  • Page 8: Parts

    Parts Parts Torque to 80 in-lb (9 N•m) Torque to 80 in-lb (9 N•m) ti14649a 313643F...
  • Page 9 113082 O-RING 16H294 ADAPTOR, angled (not shown) 16H295 RING, locking (not shown) Air Motor Repair Kits may be purchased separately. Order Kit 207335 for Model 24C728 (low viscosity) or Kit 224954 for Model 24C729 (high viscosity). Dimensions 2 in. Bung Adapter...
  • Page 10: Technical Data

    Air consumption at 400 rpm with 100 psi (0.7 MPa, 7 bar) air inlet pressure Model 24C728 (low viscosity) ....12 scfm (0.34 m /min) Model 24C729 (high viscosity).
  • Page 11 Technical Data 313643F...
  • Page 12: Graco Standard Warranty

    With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.

This manual is also suitable for:

24c72924c728 b24c729 b

Table of Contents