How To Add A Gateway Using The Configuration Tool - Honeywell NOTIFIER ONYX FirstVision Installation And Operation Manual

Enabling F V to Monitor Your Building Establish Gateway Communication
IRST ISION
It is anticipated that the factory settings for a gateway may probably work for your application and
it is recommended you use them, if possible, instead of setting up new settings. If you want to
change the factory settings use the following information
NOTE: Your LAN connection must be established before you add a gateway.

How To Add a Gateway Using the Configuration Tool

The gateway can be changed here, but F V can monitor only one gateway.
IRST ISION
NOTE: If you change the gateway IP address, you must re-export your building design to XML.
" in
See "How to Export Your Building Design for Copying to F V ONYX®F V ™
IRST ISION IRST ISION
Configuration Tool Manual - 53035
.
NOTE: The factory default Gateway IP address setting is: 192.168.0.3. If you need to change
this setting, then use the following information.
Step 1. Start the Configuration Tool.
Step 2. Select Tools > Gateway Configuration.
Step 3. Enter the Gateway IP address.
Step 4. Click OK.
Figure 3.14 Gateway Configuration
Step 5. Close the Configuration Tool.
Step 6. You should now "Copy Your Exported Building Design to F V ".
IRST ISION
24 F V ™ Installation and Operation Manual - P/N: 53034:Rev: A2 10/29/07
IRST ISION