Irst Vision; Process Overview; Process Steps To Enable First Vision; Make Connections To First Vision - Honeywell NOTIFIER ONYX FirstVision Installation And Operation Manual

Section 3 Enabling F

3.1 Process Overview

The procedures documented in the section should be performed after your building's life safety
monitoring system has been customized to F
Configuration Tool (refer to ONYX® F
for information).
Process Steps to Enable F
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
3.2 Make Connections to F
All of the procedures in this section require you to operate F
Because of that operation usage scenario, you MUST connect an external keyboard and a mouse to
F V
IRST ISION
3.2.1 What To Connect and How To Make the Connections
Step 1. Connect a keyboard and mouse to the either of these connectors.
NOTE: You must unlock the front door of F
.
NOTE: To gain access to the PS/2 connectors, you must remove the screws holding the LCD
closed and then you must swing the LCD out.
F V ™ Installation and Operation Manual - P/N: 53034:Rev: A2 10/29/07
IRST ISION
IRST
Building
IRST
"Make Connections to F
IRST
"Turn on Power to F V
IRST
"Establish Communication Between Your LAN and F
"Establish Gateway Communication".
"Copy Your Exported Building Design to F
"Test Your Building Design on F
IRST
.
• USB ports on the front of F
port (for the mouse) is ideal for connecting to F
• PS/2 connectors located on the bottom of the LCD (Figure 3.2).
Figure 3.1 F V
IRST ISION
V to Monitor Your
ISION
V using the ONYX® F
IRST ISION
V ™ Configuration Tool Programming Manual
IRST ISION
V
ISION
V ".
ISION
".
ISION
V
IRST ISION
V ".
IRST ISION
V
ISION
IRST
V LCD (recommended). A keyboard with a USB
IRST ISION
IRST
to gain access to the USB ports.
V
IRST ISION
USB Keyboard and Mouse Connections
V ™
IRST ISION
V ".
IRST ISION
".
V like a personal computer.
ISION
V (Figure 3.1).
ISION
15