Table of Contents
Advertisement
F
V
Installation Instructions
IRST
ISION
2.2 Enclosure Installation
Refer to "LCD Installation" on page 14 if the enclosure is already installed.
NOTE: You can use this information to install the F
supply connections to the enclosure's control board or you can refer to the ONYX®F
Enclosure Installation Instructions (P/N 53105).
Use the following information as a guideline to accomplish the installation of the F
enclosure and prepare the power supply components/connections for the F
Perform all installations in accordance with building construction, local code requirements, and/or
as described in the manufacturer's documentation.
Step 1. Mount the F
Step 1a.Prepare a rough opening in the wall at the location F
NOTE: The dimensions shown are the exact measurement of the enclosure. Make the
enclosure hole slightly larger (approximately 1/8") than the enclosure's dimensions for an easier
fit.
Step 1b.Remove the enclosure's knockout(s) that will be used to route your LAN cable and
Step 1c.Place the enclosure inside of the rough opening (with the LCD hinges on the left).
Step 1d.Attach the enclosure to the wall at the six locations provided using field supplied
NOTE: Make sure the enclosure is level before fastening it to the wall.
Step 2. Mount the external power supply according to the manufacturer's instructions.
Step 3. Route the external power supply wiring into the enclosure through one of the available
WARNING: Electrical Panel Breaker Lockout Procedures
!
Leave electrical panel breaker lockout safety procedures in place until you are ready to install and
connect the F
NOTE: Adhere to electrical panel breaker lockout safety procedures.
12
V
enclosure on an inside wall of the building.
IRST
ISION
according to the enclosure's dimensions specified in Figure 2.1 on page 13).
power supply's cable through.
fasteners.
knockouts, and then connect it to the control board as shown in Figure 2.2 on page 14.
V
LCD.
IRST
ISION
F
V
™ Installation and Operation Manual - P/N: 53034:Rev: A2 10/29/07
IRST
ISION
V
enclosure and to make power
IRST
ISION
IRST
V
will be mounted
IRST
ISION
Enclosure Installation
V
™
IRST
ISION
V
IRST
ISION
V
LCD.
ISION
Mounting Hole
(6 places)
Hide quick links:
Advertisement
Table of Contents
