Table of Contents
Advertisement
Operation and configuration
7.1 Normal operation
Caution
If moisture condensation occurs, wait at least about 12 hours before you switch on the
device.
1. Connect the device to the power mains.
2. Plug the power supply cable of the device into a socket with a grounded protective
conductor.
3. Switch on the power switch of the device.
The device is now in operation and booting.
Caution
Danger of data loss!
Do not switch off the power supply when the device is in operation. Disconnect the power
only after the device has been correctly shut down.
After switching on the power supply, the device performs a self test. During the self test,
the message "Press <F2> to enter SETUP" appears briefly.
When the self test is finished, the operating system will be loaded and the desktop will be
displayed.
The booting process has been completed successfully.
Switch off the device
Shut down the operating system correctly before switching off the device.
Caution
Wait for the display to go dark.
Then switch off the power switch of the device.
Warning
Always pull out the power cable to isolate the device from the mains.
7.1.2
BIOS settings
A USB keyboard is not fully available before Windows starts up. There are not restrictions to
using a USB keyboard when editing the BIOS. To be able to select a boot menu before
Windows starts, however, connect a PS/2 keyboard.
7-2
Operating Instructions, Edition 10/2004, A5E00339979-01
Panel PC IL 77
Advertisement
Table of Contents
