Table of Contents
Advertisement
3.3
Noting the identification information
3.3
Procedure
1. Write down the Microsoft Windows Product Key of the Certificate of Authenticity COA in
the table at the end of this section. The product key can be found at the back of the
device. You will need the product key during the reinstallation of the operating system.
2. Write down the manufacturer's number SVP and the order number , e.g. "6AG71...", in
the table. If repairs are necessary, the device can be identified by the service center on
the basis of the SVP number and order number.
Both numbers can be found on the rating label attached to the side of the device where
the power unit is located.
Figure 3-1
3. Write down the Ethernet address of the device: The Ethernet address is located in the
"Main" menu of the BIOS setup, "Hardware Options > Ethernet Address."
Identification
1
Microsoft Windows Product Key
2
SVP number
3
Order No.
10
Ethernet address
3.4
Guidelines for Handling Electrostatic Sensitive Devices (EMC)
3.4
Electromagnetic Compatibility
The device fulfills the requirements of the EMC law of the Federal Republic of Germany as
well as the EMC Guidelines of the Single European Market.
The device is designed as a built-in model with front-sided Protection Class IP 65. Ensure
compliance with the EN 61000-4-2 standard by installing the device in grounded metal
cabinets, e.g. MC cabinets, Siemens catalog NV21.
Note
Please refer to the appendix for for more information concerning the EMC requirements.
Panel PC IL 77
Operating Instructions, Edition 10/2004, A5E00339979-01
Rating label of the device, for example
Planning deployment
3.3 Noting the identification information
Number
3-3
Advertisement
Table of Contents
