Integration In Tia; Industrial Communications; Profibus/Mpi Interface And Winac Card - Siemens SIMATIC Panel PC IL 77 Operating Instructions Manual

Integration in TIA

9.1

Industrial communications

9.1
Introduction
The following options are available for integrating the device in existing or planned system
environments and networks.
Ethernet
The integrated Ethernet interface can be used for communication. and data exchange to
automation devices such as SIMATIC S7.
You require suitable software for this: STEP7, WinCC, ProTool, WinCC flexible, WinAC,
SIMATIC NET.
PROFIBUS / MPI
You can use a floating PROFIBUS interface to connect distributed Field devices or to
interconnect to SIMATIC S7.
You require suitable software for this: STEP7, WinCC, ProTool, WinCC flexible, WinAC,
SIMATIC NET.
Further information
For further information, refer to the catalog and to the online ordering system from Siemens
A&D.
Internet address: https://mall.ad.siemens.com
9.2

PROFIBUS/MPI interface and WinAC card

9.2
Note
You can use a CP 5613 communication module for the PROFIBUS/MPI interface. A
PROFIBUS/MPI interface is also provided on WinAC cards.
You can find further information in the documentation for the CP 5613 communication
module and in the "Servicing and Maintenance" chapter under the section "Installing and
Removing Hardware Components", "PCI/WinAC Cards".
Panel PC IL 77
Operating Instructions, Edition 10/2004, A5E00339979-01
9
9-1