Gear Oil - BRP Johnson 4HP Service Manual

GEARCASE INSTALLATION
•
Apply Moly Lube to the driveshaft splines.

Moly Lube
•
Apply Silicone Seal to the gearcase retaining nuts and
tighten the nuts to the specified torque. (retaining bolts for
the transom "S" model)

Silicone Seal

Gearcase nut / bolt: 17 N·m (1.7 kg-m; 12.5 lb-ft)
NOTE:
When installing the gearcase to the driveshaft housing,
check for the following points.
•
The water tube is through the hole in the guide plate.
•
The water tube lower end is installed into the water pump
outlet hole.
•
The shift rod is through the rod connecting plate.

GEAR OIL

Fill the gearcase with the specified gear oil. (See page 2-6)

HPF XR Gearcase Lubricant
GEARCASE
GEARCASE INSTALLATION
8-15