BRP Johnson 4HP Service Manual page 133

7. Remove the two bolts securing the propeller shaft bear-
ing housing.
8. Remove the propeller shaft bearing housing.
NOTE:
Pry the housing with a screwdriver into the groove as shown
in the figure. (2-positions)
9. Remove the four nuts and washers.
10. Remove the water pump case.
11. Remove the following parts.
•
Water pump impeller
•
Key
•
Dowel pin
•
Pump under panel
12. Remove the bolt and the shift rod guide stopper.
GEARCASE
REMOVAL AND DISASSEMBLY
8-3