MIDSECTION
STEERING BRACKET / DRIVESHAFT HOUSING / SWIVEL BRACKET / CLAMP BRACKET
Swivel Bracket / Clamp Bracket
Do not re-use the cotter pin once removed. Always use a
new cotter pin.
•
Apply Triple-Guard grease to the clamp bracket bushings.
Triple-Guard grease
•
Tighten the clamp bracket shaft nut to the specified torque.
Clamp bracket shaft nut:
25 N·m (2.5 kg-m; 18.0 lb-ft)
•
Apply Nut Lock to the clamp bracket lower rod nut.
Nut Lock
Driveshaft Housing / Steering Bracket
•
Apply Triple-Guard grease to the following parts:
•
Inside and outside surfaces of the bushings
•
Inside surface of the lower mount
•
Steering adjuster
Triple-Guard grease
•
Install the upper mount and the lower mount positioned as
shown in the figure.
7-12