Table of Contents
Advertisement
P C / 1 0 4 M o d u l e
2.21 Floppy Connector (CN11)
You can attach one 3.5" floppy drive to the PCM-5335's onboard
controller. A 34-pin flat-cable connector is fitted on one end of the
cable converter, while the other end has one floppy disk drive
connector. It consists of a 34-pin flat-cable connector (for the 3.5"
drives).
Connecting the floppy drive
1.
Plug the 34-pin flat-cable connector into the cable converter.
Make sure that the red wire corresponds to pin 1 on the
connector.
2.
Attach the appropriate connector at the other end of the cable
to the floppy drive(s). You can use only one connector in the
set. The set at the other end (after the twist in the cable)
connects to the A: drive.
When connecting a 3.5" floppy drive, you may have some difficulties
in determining which pin is number one. Look for a number on the
circuit board indicating pin number one. In addition, you should
check if the connector on the floppy drive has an extra slot. If the
slot is up, pin number one should be on the right. Please refer to any
documentation that came with the drive for more information.
Chapter 2 Quick Installation Guide
P C M - 5 3 3 5
2 - 23
Advertisement
Table of Contents
