Rite Rate Console Cable Preparation - BALZER ELIMINATOR VACUUM TANK Series User Manual

TROUBLESHOOTING
Rite Rate Flow System Programming (Continued)
6 . Press Boom Cal
7 . Press the Up Arrow
8 . Press Speed Cal
METER
9 . Press Meter Cal
VALVE
10 . Press Valve Cal
11 . Press Rate 1 Cal
12 . Press Rate 2 Cal
Rate 1 and Rate 2 can have any desired application flow rate, however, both need to have a flow rate entered to complete
setup . These rates can be changed through this console after the setup is completed .
Record your settings for Boom Width, Rate 1, and Rate 2 for future reference should the controller need to be reprogrammed .
Boom Width (in Inches)
If the controller needs to be reprogrammed, press and hold
For additional information on the Raven SCS660 NVM Controller, see the manufacturer's manual that came with the unit .
For additional information on the Sky Trak GPS, see the manufacturer's manual that came with the unit .
For additional information on the Krohne Optiflux Flow Meter and Signal Converter, see the manufacturer's manuals that came
with the unit .

Rite Rate Console Cable Preparation

The Console cable should come prepared for immediate use . If needing to prepare the Console Cable, use the following steps .
1 . Open wire loom and pull the Orange wire back towards the 16-pin plug until it is about halfway between the 16-pin plug
and where the Red and White wires exit the Console Cable .
Eliminator Vacuum Tank (Tandem) User Manual
BOOM
CAL
ENTER ENTER
3
= 150 (this is the width of the plow/injector toolbar in inches)
1
to check the remaining Booms . The value for the remaining booms should be 0 .
SPEED
CAL
4 ENTER ENTER
= 598 (this is the value for the Sky Trak GPS)
CAL
5 ENTER ENTER
= 50
CAL
6 ENTER ENTER
= 43
RATE 1
CAL
7 ENTER ENTER
= 2500 .0
RATE 2
CAL
8 ENTER ENTER
= 3000 .0
Cut Points
(be sure to remember the 0 following the decimal point)
Rate 1
CE
while turning the power on then start with Step 2 above .
Figure 63
Rate 2
45