Suspension Height Adjustment - BALZER ELIMINATOR VACUUM TANK Series User Manual

MAINTENANCE

Suspension Height Adjustment

1 . Position the tractor and machine on level ground .
2 . Connect the two (2) yellow marked hoses to the tractor .
3 . Completely lower the machine by disengaging the straight steer function and opening all ball valves . Once the machine
is completely lowered, close all ball valves .
4 . Engage the straight steer function .
5 . Open the Left Side Base End ball valve and the Rod End ball valve slowly and simultaneously (Figures 41 and 42) . The
cylinders can be filled by opening the valves a little . This will provide more control while filling the cylinders .
6 . Raise the machine until the measurement of both exposed rods of the left cylinders equals 14" (35 .6 cm) . This will leave
the necessary average of 7" (17 .8 cm) of exposed rod (Figure 43) .
7 . Close both valves .
8 . Repeat for the right side cylinders .
The machine now has the suspension properly adjusted for operation .
Figure 41
Cylinder Base Hydraulic Connection
Cylinder Rod Hydraulic Connection
Eliminator Vacuum Tank (Tandem) User Manual
Figure 43
6"
7" Average
Front
Cylinder
Figure 42
Front Cylinder Height: 6"
Rear Cylinder Height: 8"
Total Height: 14"
# of Cylinders:
Average Height Calculation
14" ÷ 2 = 7"
8"
Rear
Cylinder
Hydraulic Connection to
All Cylinder Rods
Hydraulic Connection to
Right Side Cylinder Bases
Hydraulic Connection to
Left Side Cylinder Bases
2
33