BALZER ELIMINATOR VACUUM TANK Series User Manual page 33

MAINTENANCE
Daily and Before Start of Season (Continued)
8 . Check for solid, hard, or frozen substances on all moving parts . Remove substance to avoid damaging the machine .
9 . Grease all points shown in Figures 31, 32, 33, 34, and 35 . Grease steering system according to "Steering System
Lubrication" on Page 30 . Grease vacuum pump according to "Vacuum Pump" on Page 37 .
Figure 31
Grease points on both sides of Bull
Pull hitch .
Figure 34
Tie rod
Tie rod grease point
Apply grease to both grease points on the
tie rod and the kingpin grease point on each
wheel . If the kingpin grease point is connected
to a grease line, the grease point is located on
the right side rear of the frame . If there is no
kingpin grease point, the kingpin has a poly
bushing and does not need any grease .
After Starting Tractor
10 . Check braking system for proper working operation .
11 . Recheck all hoses and connections for leaks .
12 . Check all lights for proper operation . Replace as needed .
13 . Grease according operational requirements stated on the machine .
WARNING
Eliminator Vacuum Tank (Tandem) User Manual
Figure 32
Grease points on both universal
joints of the PTO shaft and on the
shaft itself .
Kingpin Grease
Point
Kingpin
Hydraulic and brake lines are under high pressure
when tractor is running. Hydraulic fluids can become
hot enough to cause serious burns. Use proper safety
equipment when checking lines.
Two (2) grease points on each brake
caliper .
Figure 35
3rd Extension Pivot
Figure 33
2nd Extension Pivot
1st Extension Pivot
Upper and
Lower Boom
Swing Plates
29