Boom Operations - BALZER ELIMINATOR VACUUM TANK Series User Manual

OPERATION
3rd Extension
2nd Extension
1st Extension

Boom Operations

After positioning the unit by the source tank,
1 . Move the boom off of the Boom Saddle and lower so the flexible suction tip can be
attached to the boom (Figure 23) .
2 . Check the pump to see that it is set to Vacuum (Figure 24) .
3 . Position the boom over the source tank opening and lower the flexible suction tip into
the source tank .
4 . Open the Boom Valve . This will open the valve located at the front of the tank and will
close the valve located inline with the boom suction tube . With the inline valve closed,
a suction will be created when the vacuum pump is engaged allowing the manure to
be drawn out of the source tank .
5 . Engage the the hydraulic motor to operate the vacuum pump .
6 . Monitor the fill gauge and disengage the vacuum pump when the tank is full .
Eliminator Vacuum Tank (Tandem) User Manual
Figure 21
Figure 22
Boom Valve
Boom Valve
Hydraulic Hatch
Boom Swing
Figure 23
23