Slurry Pump Not Working; Rite Rate Flow System - BALZER ELIMINATOR VACUUM TANK Series User Manual

TROUBLESHOOTING
Vacuum Pump Not Working (Continued)
3 . Check the hydraulic motor:
A . Check that the hydraulic lever controlling the hydraulic motor is engaged .
B . Check hydraulic hoses for proper connection to tractor .
C . Check hydraulic hoses for leaks .
D . Check the tractor's hydraulic fluid levels .
4 . Check vacuum and pressure hoses coming off the vacuum pump for any leaks .
5 . Check the flexible suction tube on the boom for any leaks .
6 . Check the vacuum pump's internal vanes for excessive wear .
7 . If the pump is still not working, call Balzer's Service Department at 1-800-795-8551 Ext . 134 (or press 0 for the operator),

Slurry Pump Not Working

1 . Check if tank is empty .
2 . Hydraulic Motor drive:
A . Check that the hydraulic lever controlling the hydraulic motor is engaged .
B . Check hydraulic hoses for proper connection to tractor .
C . Check hydraulic hoses for leaks .
D . Check the tractor's hydraulic fluid levels .
3 . Check if the gate valves are open or closed .
4 . If the pump is still not working, call Balzer's Service Department at 1-800-795-8551 Ext . 134 (or press 0 for the operator),

Rite Rate Flow System

Raven SCS660 NVM Not Working
1 . Check to see if the Raven SCS660 Controller is turned on .
2 . If the Raven SCS660 Controller is not turning on, turn off unit and check fuse on back of the controller (Figure 62) . If
fuse is blown, replace with a 15 AMP 32V Glass Tube fuse .
3 . If the 15 AMP fuse is not blown, check the 20 AMP Blade Fuse that is located inline with the Red wire on the Raven
SCS660 Console Cable attached to a key switched 12 VDC power source .
Eliminator Vacuum Tank (Tandem) User Manual
Figure 62
15 AMP Glass Tube Fuse
Fuse Cover
43