Table of Contents
Advertisement
Available languages
Available languages
•
In case of skin or eye contact, follow the instructions
below.
Warning! The battery fluid may cause personal injury or
damage to property. In case of skin contact, immediately
rinse with water. If redness, pain or irritation occurs seek
medical attention. In case of eye contact, rinse immediately
with clean water and seek medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
•
Use your BLACK+DECKER charger only to charge the
battery in the appliance with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
•
Never attempt to charge non-rechargeable batteries.
•
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
•
Do not expose the charger to water.
•
Do not open the charger.
•
Do not probe the charger.
•
The appliance/battery must be placed in a well
ventilated area when charging.
Electrical safety
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
Symbols on the charger
Read all of this manual carefully before using the
appliance
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
Short circuit proof safety isolating transformer.
The mains supply is electrically separated from
the transformer output.
SMPS
Indication of polarity.
The charging base is intended for indoor use
only.
(Original instructions)
Labels on appliance
The following symbols appear on this appliance along with
the date code
Read all of this manual carefully before using the
appliance
JOD-S-180050BS
JOD-S-180050BS
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Dust bowl release button
3. Dust bowl
4. Chassis on/off power switch
5. Brush control switch
6. Upper handle
7. Main chassis
7a. Chassis release button
8. Floor head
9. Floor charging base
9a. Tool storage
10. Charger
11. Brush tool accessory
12. Crevice tool accessory
Use
Switching on and off (Fig. A)
•
To switch on, press the on/off switch (1) located on the
handle of the main unit (1), or alternatively on the chassis
handle (4).
•
To switch off, press the on/off switch (1) or (4).
Using Accessories (Fig. B)
•
The appliance is supplied with a brush tool (11) and a
crevice tool (12).
•
Fit the chosen accessory into the front of the appliance
as shown in Figure B.
Fitting the upper handle to the main chassis (Fig. C, D)
•
The stick vac chassis is supplied in 2 parts, the upper
handle (6) and the lower chassis (7), but they are
connected by a wire.
•
Slide the upper handle (6) into the main chassis (7) as
shown in figure C.
•
Ensure the wire is not trapped.
•
Secure with retaining screw (13) as shown in figure D.
Fitting the floor head to the Chassis (Fig. E)
•
Slide the main chassis (7) into the floor head (8) until an
audible click is heard, as shown in figure E.
ENGLISH
7
Advertisement
Table of Contents
