Seat ALHAMBRA Owner's Manual page 347

Note
The vehicle can only be towed if the electronic parking brake and steering
lock are deactivated. If the vehicle has no power supply or there is an elec-
tric system fault, the engine must be started using jump leads to deactivate
the electronic parking brake and electronic steering lock.
Fitting the front towline anchorage
The location for the removable towline anchorage is on the right-hand side
⇒ F ig.
of the front bumper 220.
The towline anchorage should always be kept in the vehicle.
Note the instructions for towing ⇒ p age 344.
To fit the towline anchorage
● Take the towline anchorage from the vehicle tool kit ⇒ p age 323.
● Press on the upper cover and carefully remove it forwards. Allow the cov-
er to hang.
Safety First
Fig. 220 On the right-
hand side of the front
bumper: Screw in the
towline anchorage
Operating instructions
● Screw in the towline anchorage into its position anticlockwise as far as
⇒ F ig. 220 ⇒ . Use a suitable tool to firmly tighten the towline
it will go
anchorage in its location.
● After towing, remove the towline anchorage by turning it clockwise and
put the cover back in place.

CAUTION
The towline anchorage must always be completely and firmly tightened.
Otherwise, it could be released while towing and tow-starting.
Fitting the rear towline anchorage
The location for the removable towline anchorage is on the right-hand side
⇒ F ig.
of the rear bumper 221. For vehicles with a factory fitted towing brack-
et, there is no fitting behind the cover to insert the towline anchorage. For
towing, fit and use the tow hitch ⇒ p age 236, ⇒ .
Note the instructions for towing ⇒ p age 344.
Practical tips
If and when 345

Fig. 221 On the rear
bumper, to the right hand
side: Tow ring in position

Technical Specifications