Seat ALHAMBRA Owner's Manual page 286

284 Checking and refilling levels
Checking the engine oil level and topping up Preparations
● Park the vehicle on flat ground so that the engine oil reading is correct.
● Stop the engine and wait a few minutes for the oil to drain back into the
sump. When the engine has cooled down, immediately check the oil level
and top up if necessary.
● Open the bonnet  ⇒ p age 278.
● The engine oil filler neck can be recognised by the symbol  on the
⇒ F ig. 171
cap
Checking the engine oil level
● Pull out the dipstick and wipe it on a clean cloth.
● Replace the dipstick, pushing it in as far as it will go. If the dipstick has a
mark, when you reintroduce it this mark should slot into the corresponding
groove located on the upper end of the tube.
Fig. 170 Marked engine
oil dipstick
● Remove the dipstick again and check the engine oil level ⇒ t able on
page 284.
● After reading the oil level, replace the dipstick in the tube completely.
Engine oil topping up ranges
Fig. 170
Area
A
Area
B
Area
C
Fig. 171 In the engine
compartment: Engine oil
filler cap
Adding oil after checking the level
Only add engine oil in small quantities and in steps.
and the dipstick by its coloured handle.
Operations required depending on the engine oil topping
up level:
Do not top up oil ⇒ .
Add approximately 0.5 L of oil (1/2 quarter of a gallon).
The oil level can be in the zone , but never above
A
It is essential to add oil (approximately 1 litre or quarter of
a gallon). Ensure that the level is around the centre of the
zone after adding oil.
B
.
A
