Seat ALHAMBRA Owner's Manual page 335

To replace the xenon headlights bulb
There is no need to remove the headlight to replace bulbs.
Complete operations only in the sequence given:
Safety First
Fig. 207 In the engine
compartment: Turn signal
cover
Fig. 208 Turn signal
lamp holder and turn-
1
ing light
2
Operating instructions
Turn signals
1
Always take the checklist into account and take the necessary ac-
1.
tions ⇒ p age 330.
Open the bonnet  ⇒ p age 278.
2.
⇒ F ig. 207
Rotate the cover in the direction of the arrow and remove
3.
Rotate the lamp holder
1
⇒ F ig. 208
to the left all the way
4.
and pull it out backwards with
the bulb.
Depending on the model, the bulb is removed directly from the
5.
lamp holder or it may need to be rotated and then removed.
6. Replace the faulty bulb by a new identical bulb.
Place the bulb holder in the
7. headlight and rotate to the right
all the way.
⇒ F ig. 207
Rotate the cover in the opposite direction to the arrow as
8.
far as it will go.
Always seek the help of a specialist when changing the Xenon dipped beam
and main beam headlamps ⇒
in Introduction on page 329.
Note
The illustrations show the left hand headlight. The structure of the right
hand side headlight is symmetric.
Practical tips
If and when
Turning lights
2
it.
Press the wire clip downwards
and pull the lamp holder
2
⇒ F ig. 208
out with the bulb.
Place the lamp holder in the
headlight and pull the wire clip
upwards until it clicks into place.

Technical Specifications
333