Checking the engine coolant level and refilling
If the coolant level is low, the coolant warning indicator will light.
Safety First
Fig. 173 In the engine
compartment: Marking
on coolant expansion
tank
Fig. 174 In the engine
compartment: Coolant
expansion tank cap
Operating instructions
Preparations
● Park the vehicle on even, flat and firm ground.
● Allow the engine to cool ⇒
.
● Open the bonnet ⇒ p age 278.
● The coolant expansion tank is easily recognisable because of the sym-
⇒ F ig.
bol on the cap
174.
Checking the engine coolant level
● When the engine is cold, check the coolant level using the side marking
⇒ F ig.
on the expansion tank
173.
● If the level is below the "MIN" mark, top up with coolant. When the en-
gine is hot it may be slightly above the marked area.
Topping up the engine coolant level
● Always protect your face, hands and arms from hot coolant and steam
using a large, thick cloth over the coolant expansion tank cap.
● Remove the cap very carefully ⇒
● Only refill using new engine coolant according to SEAT specifications
(⇒ p age 288) ⇒ .
● The engine coolant level should be between the marks on the coolant
⇒ F ig.
expansion tank
173. Do not exceed the top level of the marked area
⇒ .
● Screw on the cap tightly.
● If, the event of an emergency, you have no coolant that is compliant to
the required specifications (⇒ p age 288), never use another type of addi-
tive. Instead, first top up with distilled water ⇒
the correct proportion of the mixture with the correct additive as soon as
possible ⇒ p age 288.
Practical tips
Checking and refilling levels
.
only. Then re-establish
Technical Specifications
289