Nice NEOSTAR T Series Instructions And Warnings For The Fitter page 4

4) Programming
A reverser switch, enabling the simultaneous activation of both elec-
tric motor phases, must be used for the programming operations.
The special TTU control unit can be used for this purpose.
If you do not wish to activate the RDC torque reduction function, proceed as follows:
Table "A1" Programming the "0" and "1" positions without RDC (fig 7)
1. Press and hold down the
2. Wait for the motor to stop so that the awning is fully rolled up (position "0").
Then release the
3. Press and hold down the
4. Release the
Operate the
5. Simultaneously press and hold down the
6. Wait approximately 3 seconds for the awning to move briefly up and down and then stop
again in the position you have just programmed
7. Release the
Note: If you later wish to enable the RDC torque reduction function, you must erase the memorised positions (see table A3) and then
reprogram them with the RDC function (see table A2).
If you wish to enable the RDC torque reduction function, which activates only during the UP manoeuvre a few centimetres before the "0"
position is reached, proceed as follows:
Table "A2" Programming the "0" and "1" positions with RDC (fig 8)
1. Press and hold down the
2. Wait for the motor to stop so that the awning is fully rolled up (position "0").
3. While still pressing the
4. Wait for the awning to move briefly DOWN.
5. Release the
6. Press and hold down the
7. Release the
Operate the
8. Simultaneously press and hold down the
9. Wait approximately 3 seconds for the awning to move briefly up and down and then stop
again in the position you have just programmed.
10. Release the
Note: If you later wish to disable the RDC torque reduction function, you must erase the memorised positions (see table A3) and then
reprogram them without the RDC function (see table A1).
If after the programming operations the motor is moved to a different awning, the memorised positions must be erased:
Table "A3" Erasing the "0" and "1" positions and the RDC function (fig 9)
1. Simultaneously press and hold down the
2. Wait approximately 3 seconds for the awning to move briefly up or down.
3. Release the
Note: The erasing operation can only be carried out if a complete programming of the positions has already been executed; this happens
when the motor turns in both directions without the brief interruption at the starting of the movement.
4
control to raise the awning.
control.
control to lower the awning.
control when the awning has reached the desired position ("1").
and controls as many times as necessary to adjust the position.
and controls
control to raise the awning.
UP control, press also the
and controls.
control to lower the awning.
control when the awning has reached the desired position ("1").
UP and DOWN controls as many times as necessary to adjust the position.
and controls.
and controls.
Button is used to raise the awning; button
the movement is reversed, invert the two motor phases.
and controls.
DOWN control.
and controls.
and DOWN controls.
is used to lower it. If
Example
3s
Example
3s
Example
3s