Otto Bock Genium Patient Information page 18

1. Use to select "Settings" from the main menu and confirm using the input key.
2. Select "Pairing" from the menu that appears.
3. The Remote Control searches for additional prostheses within range.
4. Use the input key to confirm once another prosthesis has been found. If several additional prostheses
are found, the serial number of the desired prosthesis has to be selected using the navigation keys
(display: serial number). Use
One of the existing connections can also be overwritten. The configuration files are loaded from the
prosthesis and the main menu is displayed.
To delete an existing connection, please follow the steps below:
1. Use to select "Settings" from the main menu and confirm using the input key.
2. In the menu that appears, select "Delete connection" and confirm using the input key.
3. Select the connection you wish to delete using
Connecting to the Prosthesis during Normal Operation
INFORMATION
Advise your patients of the information in this section.
If more than one connection has been saved, a selection menu for the saved connections appears after
powering up; the most recently active connection is pre-selected here.
1. To change the active connection, select the name of the current connection in the main menu and
press enter to confirm.
2. In the list of saved connections which is then displayed, select the required connection and press
enter to confirm.
3. If the chosen connection cannot be re-established, a reduced main menu appears. Choose „Se-
lect device" to activate another selected connection.
In some cases following service, the connection cannot be restored even though the joint is within
range of the remote control. In this case, the existing connection must be erased and the pairing
process has to be completed again.
42 | Ottobock
to select one of the four positions and confirm with the input key.
and confirm with the input key.
Genium - Bionic Prosthetic System