Otto Bock Genium Patient Information page 13

Control Elements of the Remote Control
3
1. LCD screen
2. Input key
3. Navigation keys: Left
4. Charging receptacle
Initial Connection Between the Remote Control and the 3B1/ 3B1=ST Knee Joint (Pairing)
1. Turn on the Remote Control by pressing the input key. The start-up screen with the date, time and
battery capacity of the Remote Control is displayed. Without additional input, the Remote Control
turns off automatically after 5 seconds.
2. Attempt to establish a connection by pressing
3. When a knee joint is found (serial number is displayed), confirm by pressing the input key. If several
knee joints are found, the serial number of the desired knee joint has to be selected using the naviga-
tion keys (display: serial number). Then the configuration data are downloaded from the knee joint.
INFORMATION
This process can take a few minutes.
4. The main menu is displayed.
After the initial connection to the knee joint has been established successfully, the Remote Control will
connect automatically each time it is turned on (input key followed by
Genium - Bionic Prosthetic System
1
2
3
4
, right , up , down
. The Remote Control searches for active prostheses.
). No further steps are required.
Ottobock | 37