ETEKCITY B22 User Manual page 8

EN
adjusting medication used to control hypertension (or
any other reason).
• Make sure the monitor is working correctly and not
damaged before using.
• Do not make any modifications or repairs yourself. If
you have any questions, contact Customer Support
(see page 42).
• This monitor should not be serviced or maintained
while using on a patient.
Caution: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury to the user or patient, or damage to the equipment or
other property.
• People with severe blood flow problems or blood
disorders should consult a physician before using the
monitor, as the arm cuff inflation can cause bruising.
• Consult your physician before using the monitor if you
have had a mastectomy.
• Do not take measurements more than necessary. It
may cause bruising due to blood flow interference.
• Do not use the monitor for any purpose other than
measuring blood pressure.
• Do not use the monitor to check the frequency of heart
pacemakers.
• Only use the approved arm cuff for this monitor.
Use of third-party arm cuffs may result in incorrect
measurements.
8
• Do not store in any place that is tilted, vibrates, or can
damage the monitor.
• Do not store near chemicals or corrosive gases.
• Keep away from heat sources and direct sunlight.
• Do not leave the monitor exposed to any chemical
solvent, lint, or dust.
• Do not get the monitor wet or use in a wet or humid
environment. This may damage the monitor.
• Only use, transport, and store the monitor within
the required temperature and humidity ranges (see
page 4). If the temperature and humidity are
outside these ranges, the measurement results may be
inaccurate.
• Do not hit or drop the monitor.
• Do not use the monitor in a moving vehicle, such as a
car or an airplane.
• When appears, replace the batteries.
• Only use a micro USB power cable that meets the
requirements for the monitor
(see page 18).
Note: A separate micro USB power cable used with this
monitor has not been evaluated according to IEC 60601-1.
The safety of the monitor shall be reappraised when it is
powered by a separate power cable.