External Power-Supply Header - Renesas RX Series User Manual

Target Board for RX23W
5.8

External Power-Supply Header

When more current is required than the USB is capable of supplying, use the external power-supply header
(J6) to supply power. The usable voltage is 3.3 V. When this header is to be used, remove the pattern for
cutting (SS19) on the soldered side, electrically separating the emulator from the target. Figure 5-4 shows the
position of the pattern for cutting. Figure 5-5 shows the position of the external power-supply header (the
actual header component is not mounted on the board as shipped).
Pattern for
cutting (SS19)
Figure 5-4 Position of the Pattern for Cutting (SS19) (Soldered Side)
External power-
supply header
(J6)
Figure 5-5 Position of the External Power-Supply Header (J6) (Top Side)
R20UT4634EJ0102 Rev.1.02
Nov.27.19
5. User Circuits
Page 16 of 33