4. TROUBLESHOOTING
Flashing speed of the LED
Status
Flashing slowly
Flashing at medium speed
Flashing fast
4.3 Removing Jammed Media
This section describes in detail how to remove jammed media from the printer.
CAUTION!
Do not use any tool that may damage the print head.
1. Turn the power off.
2. Open the Top Cover and remove the media roll.
3. Remove the jammed media from the printer. DO NOT USE any sharp implements or tools as these could
damage the printer.
4. Clean the Print Head and Platen, then remove any further dust or foreign substances.
5. Load the media again, and close the Top Cover.
Flashing interval
1 sec.
0.5 sec.
0.2 sec.
E4- 3
ENGLISH VERSION EO1-33088
4.3 Removing Jammed Media