Toshiba B-EV4D SERIES Owner's Manual page 19

2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
NOTE: Media path
Feed Gap Sensor
Platen
Black mark sensor
NOTES:
1. Refer to the Supply Path Label
attached inside of the Top
Cover.
2. Make sure that the print side
faces up.
3. Cut the leading edge of the
media straight with scissors.
NOTE:
Do not forcibly move the Media
Guides by hand, as doing so may
break the Media Guides.
2. Slide the Media Holder Lock Switch to the Unlock (▲) side to
release the Media Holders.
Media Holder
Lock Switch
3. Open the Media Holders.
Media Holder
4. Place a media roll between the Media Holders so that the media is fed
with the print side facing up. Fit the projection of the Media Holders
into the core. Make sure that the projection of the both Media Holders
is engaged with the core firmly.
Media Holder
5. Turn the Media Guide Adjustment Dial in the arrow indicating
direction to move the Media Guides outward.
E2- 8
ENGLISH VERSION EO1-33088
2.7 Loading the Media
Media Holder
Media
Media Holder
Media Guide
Adjustment Dial