Overview Of Parameters At The Configuration Level - ABB LST300 Operating Instruction

3 Press
or to select the required value .
4 Press to confirm your selection
Setting a numerical parameter
1 Select the parameter you want to set in the menu .
2 Press
for parameter editing . The currently selected
position is highlighted .
3 Press
to select the decimal position to be changed .
4 Press or to select the required level .
5 Press to select the next position .
6 If necessary, select and set other decimal positions using the
same procedure as described in steps 3 and 4 .
7 Press
to confirm your setting
Setting an alphanumeric parameter
1 Select the parameter you want to set in the menu .
2 Press for parameter editing . The currently selected
position is highlighted .
L S T 3 0 0 | C O M PA C T U LT R A S O N I C L E V E L T R A N S M I T T E R | L S T 3 0 0 – E N R E V. E
3 Press
4 Press
5 Press
6 If necessary, select and set other alphanumeric positions
using the same procedure as described in steps 3 and 4 .
7 Press
Exiting the setup
Values are mandatory for some menu items . Exit a menu
without parameter change as follows:
1 Press
Once the cursor reaches the end position, "Cancel" is
displayed in the lower right .
2 Press
press
IMPORTANT (NOTE)
The LCD display automatically returns to the process display
three minutes after the last button is actuated .
Overview of parameters at the configuration
level
IMPORTANT (NOTE)
This overview of parameters shows all the menus and
parameters available on the device . Depending on the device
version and configuration, some menus and parameters may
not be visible .
The displayed menu vary in different operation modes . In this
section, menus displayed only in some operation modes are
marked with numbers in brackets . The numbers represent the
operation modes as follows:
• Level
• Flow
• Volume
Refer to section "Menu levels" for a list of operation modes
these numbers represent .
to select the alphanumeric position to be changed .
or to select the required character .
to select the next position .
to confirm your setting
repeatedly till the cursor is moved to the right .
to terminate editing and exit the menu item . Or
to return to the start .
25