Valmar MULTY P TTi Series Handling, Operating And Maintenance Manual page 86

In the most programs the permeted changing of the speed is saved.
See the relevant program info to check whether changes are stored. If changes
are NOT stored they will be valid only for the running program!
The new parameter is valid and used during the running program and will be
valid and used when running the program in future.
9.2.4.2 DESIRED TEMPERATURE
9.2.4.2.1 CHANGING OF THE TEMPERATURE
In actual step you can change desired
temperature. For this you can use two
buttons.
If you press the UP -
increase the actual temperature.
If you press the DOWN -
decrease the actual temperature.
For confirming the new value press the SET
button.
If the UP button is grey the increasing of the temperature is not allowed.
If the DOWN button is grey the decreasing of the temperature is not allowed.
In the most programs the permeted changing of the temperature is saved.
See the relevant program info to check whether changes are stored. If changes
are NOT stored they will be valid only for the running program!
The new parameter is valid and used during the running program and will be
valid and used when running the program in future.
9.2.4.3 MAINTENANCE TIME
9.2.4.3.1 CHANGING OF THE TIME
When in actual step the desired temperature
is reach you can change maintenance time.
For this you can use two buttons.
If you press the UP -
increase the actual maintenance time.
If you press the DOWN -
decrease the actual maintenance time.
For confirming the new value press the SET
button.
If the UP button is grey the increasing of the maintenance time is not allowed.
button you
button you
button you
button you
86