Valmar MULTY P TTi Series Handling, Operating And Maintenance Manual page 60

1. In running extraction step press the button
to start cooling.
2. The machine starts compressor for 10
seconds. On the thouch screen (cylinder –
right side) in tutor message show caption
Ur-FORCE_COMPRESSOR (switching of
the cooling for 10 seconds)...
After 10 seconds the machine
automatically switches off the compressor.
For the anticipated switches off the
compressor press again the freezing
buton.
If the FREEZENG button is grey the colling is not allowed.
With STOP button
7.3.1.8 Key START
The ICE CREAM
mixture in the production cylinder in trough the selected program 01 - MODE1
(ICE CREAM ) pressing this key the user activates the selected program.
3. Press the button
program 01.
4. The machine prodiucing ice cream in
MODE 1(ice cream temperature and
density check).
During production you can change value of
MODE 1 (see chapter "PROGRAM
MODIFICATIONS AND SETTINGS").
Production ends when set values are
reached. The end of the cycle is notified by
a beep and a light signal (if any). A
message is displayed to take out the ice
cream. The machine will keep ice cream
consistency automatically until extraction,
i.e. until the end of the maximum time limit.
you can stop extraction (in any phase).
button activates mixing and cooling of the ice cream
to start pre-set
60