Volkswagen PASSAT 2013 Manual page 33

Enabling and disabling displays
Use the Settings menu, submenu MFI data (Settings > MFI data) to enable displays you want to
be available under the MFI menu in the instrument cluster display. The units in which data is displayed
can also be changed ⇒ p age 34.
Applicable only in Mexico, the AGCC, and South Korea
MFI menu (Multi-Function Indicator): Premium version
Please first read and note the introductory information and heed the WARNINGS
The MFI menu has two automatic trip memories: 1 – single trip memory and 2 – total trip memory.
The number of the memory is shown at the upper right of the display. The trip memories are in addi-
tion to the trip odometer, which is displayed in the bottom part of the instrument cluster and controlled
using the 0.0 / SET button on the right of the instrument panel ⇒
To display the distance driven on trips 1 and 2, select the Route item in the MFI menu (MFI >
Route). Press the OK button (⇒
Push and hold the OK button to manually reset a trip memory to zero.
Single trip
1
memory
2 Total trip memory
Possible MFI menu displays
The following displays can be accessed in the MFI menu if enabled under Settings > MFI data.
Displays that are not enabled will not appear.
Display
Travel time
Consumption
--.- l/100 km
Av. consumption
--.- l/100 km
Range
Route
f ig. 15) to toggle between Route 1 and Route 2 (trip 1 and trip 2).
The memory accumulates and stores information about distance driven and
fuel used from the time the ignition was switched on until the time it was
switched off.
If the ignition stays off for 2 hours or more, stored information is automatical-
ly deleted. If the trip is continued within 2 hours after the ignition was
switched off, the new values are added.
The memory displays and stores the accumulated driving and fuel consump-
tion data of any number of single trips up to a total driving time of 99 hours
and 59 minutes, and up to a total distance of 9,999 km, depending on the
instrument cluster version. If one of the maximum values is exceeded, then
the memory is automatically cleared and starts again from 0.
Function
Driving time in hours (h) and minutes (min) corresponding to trip memories 1
and 2 (toggle).
Current fuel consumption in miles per gallon (l/100 km) while driving.
When units are set to miles, dashes appear instead of a number when the
engine is running and the vehicle is standing still.
When units are set to kilometers, the display shows liters consumed per
hour when the engine is running and the vehicle is standing still.
Average fuel consumption in l/100 km on trips per trip memories 1 and 2
(toggle) is displayed once the vehicle has been driven about 100 m. Until
then, dashes appear instead of a number. The value displayed is updated
every 5 seconds.
Estimated distance in km that the vehicle can go with the fuel left in the tank
the way you are currently driving. Takes account of the current fuel con-
sumption, among other things.
Distance driven in km per trip memories 1 and 2 (toggle).
f ig. 11 (7).