Maintenance And Cleaning; User Maintenance; Cleaning - Parkside PDT 40 E4 Operation And Safety Instructions

□
Close the face plate
quick clamping lever
exhaust air aperture
□
Close the magazine
tacker as described in the chapter "Loading the
magazine".

Maintenance and cleaning


RISK OF INJURY!
Be absolutely certain to disconnect the device
from the compressed air source and empty the
magazine before cleaning or maintaining it.

User maintenance


Lubrication with oil mister
NOTE: As a treatment stage after the pressure reducer,
an oil mister provides continuous and optimum lubrica-
tion of the compressed air tacker. An oil mister gives off
fine drops of oil into the airflow and so guarantees re-
gular lubrication.
▪
Install the oil mister after the (filter) pressure redu-
cer. To do so, insert the nipple of the oil mister into
the quick-release coupling of the (filter) pressure
reducer.
▪
Then connect the compressed air device to the
quick-release coupling provided for it.
Manual lubrication
NOTE: If you do not have an oil mister, lubricate the
device each time after driving about 5000 fasteners.
▪
Apply 1–2 drops of special compressed air oil
into the threaded nipple
air tacker.
▪
Then press the trigger
ATTENTION: Be certain not to use too much oil; ot-
herwise oil could leave the mouth with the fastener
and potentially damage the workpiece.
by pulling the face plate
12
in the direction of the
13
.
1
of the compressed air
7
of the compressed
4
several times.
2

Cleaning


▪
Do not use any sharp objects to clean the device
and the protective goggles. Do not allow any li-
quids to enter the device. Otherwise the device
could be damaged.
▪
Clean the device and the protective goggles
regularly, preferably always immediately after
finishing work.
▪
Use a dry cloth to clean the housing and use
a damp cloth to clean the protective goggles.
Under no circumstances should you use petrol,
solvent or cleaners which attack plastic.
▪
After each use, pack the compressed air tacker,
the protective goggles and the compressed air
special oil in the carrying case it was delivered
with to protect it from dirt.
R OWI Electronics GmbH

warranty
Dear Customer,
This appliance has a 3-year warranty valid from the
date of purchase. If this product has any faults, you,
the buyer, have certain statutory rights. Your statutory
rights are not restricted in any way by the warranty
described below.
Warranty conditions
The validity period of the warranty starts from the
date of purchase. Please keep your original receipt
in a safe place. This document will be required as
proof of purchase.
If any material or production fault occurs within three
years of the date of purchase of the product, we will
either repair or replace the product for you at our
discretion. This warranty service is dependent on you
presenting the defective appliance and the proof of
purchase (receipt) and a short written description of
the fault and its time of occurrence.
If the defect is covered by the warranty, your product
will either be repaired or replaced by us. The repair
or replacement of a product does not signify the be-
ginning of a new warranty period.
GB/CY 13