Prepare The Sensor Suite For Installation - DAVIS Vantage Pro2 Sensor Suite User Manual

Prepare the Sensor Suite for Installation

Follow the steps in order as each builds on tasks completed in previous steps. These
steps apply to all versions of the sensor suite, unless otherwise noted.
Tip: Use a well-lit work table or work area to prepare the sensor suite for installation.
Assemble the Anemometer
The anemometer measures wind direction and speed. The anemometer arm comes
partially assembled with the wind vane attached.
Note: Do not remove the vane.
Please locate the following parts to prepare the anemometer:
• Anemometer arm (wind vane and cable already attached)
• Anemometer base
• Wind cups
• Allen wrench (0.05")
• #4 machine screw, #4 tooth-lock washer, #4 hex nut
Attach the Anemometer Arm to Base
1. Insert the anemometer arm into the base, sliding the cable through the notch in the
base as shown in the illustration below.
2. Line up the small hole in the arm with the holes in the base.
3. Insert the machine screw through the holes in the base and arm. It may be helpful
to use a screwdriver to insert the screw.
Lock Washer
Hex Nut
Insert
anemometer arm
into base
Slide cable
through notch
#4 Tooth
#4 x 1-1/8"
Machine Screw
IMPORTANT:
Make sure cable
is secure in channel
5