DAVIS Vantage Pro2 Sensor Suite User Manual page 11

Check Sensor Interface Connections and Connect the
Anemometer Cable
The sensor interface is located in the transmitter shelter on the front of the sensor
suite station. It contains the connections for all the sensors of the sensor suite.
Follow the steps below to check the sensor interface and ensure that all sensors are
connected properly.
Open the Transmitter Shelter
1. Locate the white box with the solar panel containing the sensor interface on the
front of the sensor suite unit. (The cabled model does not have a solar panel.)
2. Locate the white tab at the bottom center of the shelter cover.
3. Pull the tab away from the box while sliding the cover up.
4. Look on the side of the shelter. The box cover can be easily removed from the box
when the alignment indicator on the cover is lined up with the alignment indicator
on the box
5. Pull the cover off the box, being careful not to stress the solar panel cable when
removing the cover.
6. The sensor interface is visible once the cover has been removed.
Note: See "Sensor Interface" on page 44 for information on locating the components and
points of interest on the sensor interface.
7