Table of Contents
Advertisement
•
X-series tiles are to be used in environments meeting the operating specifications.
•
X-series tiles are not to be used in environments that are subject to airborne contaminants such as that produced by smoke
machines (cracked oil) or similar (these deposit a thin layer of greasy residue upon the LEDs optics, degrading performance).
•
X-series tiles are not to be exposed to extreme localized heat or cold exceeding the temperature specifications.
•
X-series tiles are not to be exposed to any element or situation that will cause any part of the display to heat beyond what occurs
during normal operation. Such situations include but are not limited to lasers, ultrasonic vibration, or any type of substance that
prevents proper ventilation and heat radiation of the X-series tiles.
•
X-series tiles are not to be exposed to circumstances where moisture can condense or collect on any components.
•
Power connected to the X-series tiles must meet the specifications outlined in the installation manual.
•
Avoid any accidental bumping of the tile corners while installing or removing the X-series tiles. Since LED's of the X-series tiles
are mounted near by the edges of the LED boards, which is unavoidable in the design of a high resolution LED-wall, the corners
of the X-series tiles become sensitive for mechanical damage. Because of that it is required to handle the X-series tiles with
care at all times.
•
Never place an X-series tile upon a surface with the LED's facing downwards without protection. This to prevent damage to the
LEDs and the soft lens of the LEDs.
•
While removing or installing the X-series tile always keep the LED side of the X-series tile parallel with the LED side of the
remaining neighboring X-series tiles. This to avoid any mechanical stress upon the corners of the X-series tiles.
•
No force can be applied to the LEDs. Any LEDs damaged due to mechanical stress are not covered by the warranty.
•
Safety and functional features of the display cannot be defeated.
•
It is not allowed to climb or hang any additional equipment on the back of an X-series wall. Nothing is to be allowed to hang
from the cables of an X-series tile.
•
Any failures must be immediately and appropriately dealt with (equipment returned to Barco). Failing equipment cannot be left
to run in a wall.
•
No additional tools (hammers, pry-bars, etc.) are to be used to force handles or locks into place. All moving parts should be
managed by hand.
•
Only Barco cables specified to be used with the X-series display are to be used to connect components in the X-series wall.
Further, care must be taken to connect signal only according to the installation manual.
•
X-series tiles are not to be used in the vicinity of any equipment that is not CE and UL/ETL certified.
•
When reconnecting components in an X-series tile, care must be taken to ensure that cables are carefully routed according to
the installation manual to prevent damage to the cables or other parts of the X-series tile.
•
X-series tiles can be cleaned only in accordance to the procedures defined in the installation manual.
•
The X-series display is an indoor product. Use the X-series tiles only in a dry area away from direct sunlight, dust and moisture.
Never install and use the X-series tiles in an outdoor environment.
•
Ensure rigging hardware is able to handle the weight of the entire X-series with appropriate safety factors.
•
External rigging hardware must be properly installed prior to hanging X-series tiles.
R5906876 X-SERIES 24/07/2017
1. Safety
5
Advertisement
Table of Contents
