Transmitter Functions - GRAUPNER Junior Line Series Instruction Manual

Transmitter and reciver binding
Under normal circumstances, the remote control and the receiver are binded from the factory. Should
this out for whatever reason may not be like this (the LED on the receiver glows red), perform the following
steps:
1. Make sure that the left stick is in the lower position.
2. Turn the switch on the battery compartment on after you have inserted the 3 „AAA" batteries correctly.
3. Carefully remove the receiver unit from the hull, this is located in the front.
4. Now press the „BIND" button on the receiver. After a short time, the LED will turn from red to green and
thus indicate that the receiver is connected to the remote control.
5. Slide the receiver now back in the fuselage. Make sure that the antenna in the front part remains and is not
too close to the battery.
ATTENTION!
During the binding process, the transmitter must not be more than 1 meter away from the
receiver. It also should be no similar product located in the range of 10 meters, which
may affect the binding process. If the green LED flashes on the receiver
the binding process is not performed correctly. Please repeat the steps again.

Transmitter functions

When the transmitter is switched on (switch position ON) and the power supply is operating, the LED will be
lit.
1. Sail adjustment: sails can be hauled into a „neutral" position by moving the sail adjustment joystick in
direction (A). The sails will open when the joystick is moved in direction (B).
2. Rudder control (left/right): the model will make curves by moving the joystick. Moving the joystick to the
right will cause the model to turn right, moving the joystick left will cause the model to turn left. The more
turn movement executed, the smaller the model's curve radius becomes.
NOTE: this is a model sailing vessel; if the wind is too weak or too strong, navigation behavior can change
drastically! You should not use the model in strong wind because it can capsize.
Junior Line WP Soil micro Segelboot RTR 19