GRAUPNER Junior Line Series Instruction Manual page 18

Inserting the transmitter's battery
1. Check to make sure the transmitter is switched off (switch position OFF) (5).
2. Remove the cover (2).
3. Push the battery compartment cover away in the direction of the arrow.
4. Insert the batteries (4x AA) with correct polarity orientation (as marked in the bottom of the battery com-
partment). (3)
5. Close the cover. (4)
Attention!
It is very important that the stick on the left is at it´s lowest position before switch on the transmitter.
Placing the battery in the model
Place the model on the delivered ship stand.
1. Turn the table carefully to open the hatch.
2. Lift up the rear part of the hatch by holding the table. Do not hold the two steering wheel, they may be
damaged.
3. Hold the front part of the hatch on both sides, carefully pull the hatch up a little bit, then you could remove
the hatch by pulling.
4. Now inatll 3 pcs of „AAA" alkaline batteries to the reciever battery box, notice the correct polarity.
5. Push down the left stick of the transmitter till the end, then switch on the transmitter power.
6. Switch on the plug on the battery box. Observe the reciever green light soil green, if it soil red, you need to
bind the transmitter with the reciever, detaild information is given in next step.
7. After making sure the green light is on, your model is ready to use. Place the hatch again and fix with the
table.
Note: Pay attention when opening the cabin that neither of the ship's 2 wheels are broken off. Always
remove the cover carefully!
18 Junior Line WP Soil micro Segelboot RTR