Care And Maintenance; Operating Instructions - GRAUPNER Junior Line Series Instruction Manual

Important safety and operating notices for the RC system
• With the transmitter switched on, briefly press the Bind button on the receiver unit to bind the transmitter
and receiver. The LED that was blinking red will turn green after a successful binding process.
• Protect all units from dust, dirt, moisture, vibrations and other foreign parts. Also, never expose these units
to excessively hot or cold temperatures.
• Avoid mechanical jarring and pressure stresses. Always check units for damage to housings and cables.
• Never pull on cables to disconnect cable connectors.
• Avoid reversed polarity and short-circuit conditions of any kind as well as excessive power supply volt-age.
The devices are not protected against these conditions.
• Use only components which have been specified and released by GRAUPNER/SJ.
• GRAUPNER/SJ recommends that only dry-cell (i.e. primary cell) batteries be used as the transmitter's pow-
er supply. The use of rechargeable (i.e. secondary cell) batteries for this purpose is at one's own risk.
• Never attempt to recharge the power supply's dry-cell (i.e. primary cell) battery. Only rechargeable (i.e.
secondary cell) batteries may be charged.
• The battery must have an adequate charge and the remote control unit's range must be tested. If in doubt,
the transmitter's battery should be replaced when its charge state is unknown.
• If water has intruded into RC components, dry them out then send them to the responsible GRAUPNER
service center for inspection (see listing of responsible service centers at the end of these instructions).

Care and maintenance

• Clean the model after every use. Immediately remove any water which has intruded by appropriate means,
e.g. with a kitchen towel or similar. Always leave covers open/off for an extended period so re-sidual mois
ture can dry out.
• Clean the model and RC components only with suitable cleaning materials. Please contact your dealer for
information about this.
• If the model is not to be operated for a long time, all moving parts (shafts, etc.) should be taken out, cleaned
and re-lubricated. All batteries must also be removed from the model and the transmitter for separate sto
rage.

Operating instructions

Unpacking Soil
1. The model Soil is secured to the carton and its ship stand with screws.
2. Remove these 3 screws with a Phillips screwdriver as shown in the pictures below. Afterwards the model
can be taken out of its carton.
3. Remove the 2 screws on the bottom of the ship stand. Be sure to hold the model securely while do-ing this
as otherwise it can fall.
Junior Line WP Soil micro Segelboot RTR 17