Protection Functions Of The Speed Controller; Led Module; Technical Data Led Module; Connection Of The Led Module - GRAUPNER Husky 1800S Manual

Protection functions of the speed controller

LED module

Technical data LED module

Connection of the LED module

Tips and notes for the first flight

13410_13410.100_HU_V.1
1. Startup protection: If the motor does not start turning within 2
seconds after the throttle control is actuated, the controller will
switch off to prevent uncontrolled start-up. In this case, move
the throttle stick to the stop position, this reactivates the speed
controller. (This may be caused by: wrong motor connection, the
propeller is blocked, etc.)
2. Overheat protection: If the temperature exceeds 110 ° C, the
motor power is reduced.
3. Motor throttling in case of signal loss: If the signal from the
receiver is interrupted for longer than 1 second, the motor power
is reduced, the motor is switched off if the signal loss lasts longer
than 2 seconds.
4. If, after the drive battery has been plugged in, the beeps are
"beep-, beep-, beep-" (each "beep-" has an interval of 2 sec.), it
means that the drive battery has an over-voltage or under-volt-
age.
5. If, after the drive battery has been plugged in, the beeps are
"beep-, beep-, beep-" (each "beep-" has an interval of 0,25 sec.),
it means that the throttle stick is not in the motor stop position.
Weight incl. leads
Continuous current at 25°C
Operating voltage
Dimensions approx.
1. Plug the LED module into a free channel slot in the receiver.
2. Connect the LED module to the V-cable for the LEDs in the wings.
(Cable diagram 12.)
 After you have assembled the model according to instructions,
programmed the remote control according to the specification,
all the batteries have been fully charged, there is nothing else
between you and the first flight.
 For the first flight there should not be too much wind.
 The assembly of the model is very simple, the flying more sophis-
ticated.
4 g
150 mA
4,8 - 5,9 V
30 x 20 x 2 mm
25 / 76