Advertisement
Available languages
Available languages
Wingspan approx.
Overall length approx.
Wing area approx.
Weight approx.
Pack contents
Remove the battery compartment cover on the underside of the transmitter and fit the
cells in the compartment in the arrangement shown in the engraved diagram. Close
the battery compartment cover again.
Open the slider at the top of the transmitter, remove the cable and plug and connect
the plug to the socket in the underside of the model's fuselage.
Check that the switch on the model is set to OFF, then switch the transmitter on (ON)
and ensure that the red and green LEDs light up. When the green LED goes out, the
battery in the model is fully charged. Disconnect the charge plug, and the model is
ready for flying. Always recharge the flight battery using the transmitter only.
Switch the transmitter on (ON), and move the left-hand stick back towards you to its
end-point. Switch the model on by sliding the switch to the ON position: the blue LED
in the fuselage now flashes.
Transmitter functions
Left-hand stick forward = full throttle, right-hand (steering) stick = left / right.
Adjust the trim button at the right-hand transmitter stick to trim the model, i.e. to make
it fly straight ahead (neutral) with the steering stick at centre. If the model turns to the
left, press the button to the right repeatedly until the model flies straight.
Important:
When you move the left-hand stick forward, both motors run at the same speed.
Opening the throttle fully (stick fully forward) causes the model climb; reducing the
throttle setting causes it to descend.
Moving the right-hand (steering) stick to the right reduces the speed of the right-hand
motor, and the model starts to turn to the right.
We reserve the right to introduce modifications which serve to improve our products.
Channel assignment
The MICRO FILOU can be set to any of three channels (A; B; C).
If two or three models are flown simultaneously, you may need to change the channel
to ensure that each model responds only to its own transmitter; e.g. channel C.
1. Move the slider on the transmitter to C, and switch on; the red LED on the
transmitter lights up.
2. Switch the model on: a blue LED in the fuselage flashes.
3. Slowly move the left-hand (throttle) stick forward to the full-throttle point: the
motors run.
4. The transmitter and model are now programmed; switch the model and the
transmitter off.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler!
210 mm
185 mm
2.4 dm²
8 g
20
01/2008
Advertisement
