Table of Contents
Advertisement
REQUIRES
To operate your new Flash 3.0 Brushless you will need the following:
•
8 alkaline AA batteries e.g. No. 3426, or 12 AA battery cells e.g. No. 3621 for transmitter
•
2x 7.4 V LiPo-batteries e.g. No. 98997, 98998, 99000 or 99003
•
or 3-cell LiPo 11.1V e.g. No. 98990, 98991 or 9740.3 and a suitable charger like the Graupner Ultramat series
TOOLS REQUIRED
In addition to the tool that accompanied the vehicle, the following tools are useful and - in some cases - necessary:
•
Hex wrench with 1.5 mm, 2 mm and 2.5 mm (5775.1,5; 5775.2 and 5775.2,5), Nut driver 5.5mm (5783.5,5)
•
Wheel nut driver 17mm (No. 98004)
•
small needle-nose pliers
Needle-nosed pliers
THE REMOTE CONTROL SYSTEM
Here you get an overview of the remote control system of the Flash 3.0 and its various functions and settings. Before
the f rst trip you should be sure all of these functions and settings have read and understood.
First screw the enclosed transmitter antenna into the mounting plate at the top of the transmitter . Place 8 AA batteries in
the battery compartment of the transmitter. Pay attention to the polarity!
REMOTE CONTROL (TRANSMITTER)
On / off switch: Turns the power on/off
1.
Steering wheel: Controls direction (left/right) of the model
2.
Steering trim: Adjusts the "hands off" direction of the model
3.
Throttle Trigger: Controls speed (forward/brake/reverse) of the model
4.
Throttle Trim: Adjusts the motor speed to stop at neutral
5.
Control light: indicates adequate battery power
6.
Antenna: Transmits signal to the model
7.
The remote control system of the Flash 3.0 is optimally adjusted by the factory . Nevertheless you should read the follo-
wing chapter, maybe slight adjustments on the remote control should be necessary . For further information to the remote
control system please refer to the enclosed XG-6 manual.
11
Wheel nut wrench
GM-Racing 90170.RTR Flash 3.0 Race Brushless 4WD Buggy
Allen key 1.5, 2, 2.5mm
Wrench 5.5mm
Advertisement
Table of Contents
