Nordson Rhinor XD2H Instruction Sheet

Description
r
See Figure 1. The Rhino XD2H heated follower
module with steel ring mounts to Rhino XD2H pump
hydraulic sections. It is designed to force material out of
straight-sided material containers.
The heated follower module uses a PTFE-coated steel
ring (4) to pump high-viscosity urethane materials out of
foil bags. It is sized for a close-tolerance fit to the inner
diameter of the container. The ring collapses the foil bag
to prevent it from getting wedged between the follower
plate module and the container wall.
Lowering the heated follower plate module into a
container causes air buildup between the bottom of the
follower plate (2) and the material. Removing the
bleeder stem (1) from the adapter (3) before lowering the
follower plate provides a path for the air to vent.
Repair
WARNING: Allow only qualified personnel to
perform the following tasks. Follow the safety
instructions in this document and all other
related documentation.
Repairs consist of replacing the RTD and the thermostat.
Perform the following to gain access to these parts:
1. See Figure 2. Perform the following:
S
Remove the screws (1), lock washers (2), and
washers (3) securing cover A to gain access to
the thermostat.
OR
S
Remove the screws (4), lock washers (5), and
washers (6) securing cover B to gain access to
the RTD.
2. Perform the desired repair procedure.
E 2018 Nordson Corporation
Heated Follower Module with Steel Ring
1
2
1: BLEEDER STEM
2: FOLLOWER PLATE
3: BLEEDER STEM ADAPTER
4: PTFE-COATED STEEL RING
Figure
1
4
5
6
Figure
2
Issued 3/18
Rhinor XD2H
Heated Follower Module
B
Heated Follower Module
Instruction Sheet: 1085717-03
3
4
1
2
3
A