Summary of Contents for ETC Source Four LED Profile
Page 1
ETC Quick Guide ™ Source Four LED Profile Overview For complete information and step-by-step instructions, see the Source Four LED Profile User Manual. ETC documentation can be downloaded at www.etcconnect.com. Yoke Safety cable loop Accessory retainer Yoke locking knob Accessory...
Step 2: Attach a safety cable. Step 3: Insert additional accessories such as a top hat, etc. WARNING: Use only hardware rated for total weight of fixture and accessories. A safety cable (or other approved safety device) must be securely attached to the safety cable loop before loosening the clamp.
Page 3
ETC Quick Guide Source Four LED Profile Connect DMX Thru Power Thru Power In DMX In Step 1: Attach the power cable to the Power In connector. Step 2: Attach the 5-pin XLR cable to the DMX In connector (if using external control).
Page 4
ETC Quick Guide Source Four LED Profile Soft Focus Diffuser Step 1:Install the diffuser into an A-Sized Pattern holder. Step 2:Install a pattern in front of the diffuser, if needed. Step 3:Insert the pattern holder with diffuser into the Pattern holder slot, making sure the writing on the diffuser faces the front of the fixture.
ETC Quick Guide Source Four LED Profile Step 6: To exit the Quick Color menu, press [ Quick Setup Step 1: On the Main Menu, scroll to Quick Setups and press [ Step 2: Scroll to the desired setup and then press [ An asterisk (*) indicates which setup is active.
ETC Quick Guide Source Four LED Profile DMX Profiles Lustr+ and Series 2: Lustr, Daylight HD, Tungsten HD, and Studio HD Channel Assignments Notes Profile Channels Direct control of each individual color with a separate master intensity channel. Color Channel assignments in Direct calibration of LEDs is not active in this mode.
Page 7
ETC Quick Guide Source Four LED Profile Channel assignments in direct mode Channel Series 1 Series 1 Series 2 Series 2 Series 2 Number Studio HD Lustr+ Lustr Daylight HD Tungsten HD Red Orange White Lime (not used) Red Orange...
Page 8
ETC Quick Guide Source Four LED Pro le Typical Power Consumption Lustr+ 120V 240V Idle Power / Current 4.27W / 0.084A 4.38W / 0.079A 4.2W / 0.068A 100% Boost Power / Current 130.8W / 1.48A 129.9W / 1.11A 126.4W / 0.576A...