EcoWater CHC Series Service And Troubleshooting Manual page 118

13. Press the OK button on the Load Application window.
14. As the software is being up loaded this screen will be shown indicating that progress of
the upload:
15. Once the software is installed the screen will change with a window and it then asks
you if you would like to place the unit in the RUN mode. Press the OK button and the
unit should revert back to the initiation screen.
16. If any problems occur or the system does not start operating with the Initiation screen,
call EcoWater CHC Service for help. The software was designed to check its own
Check Sum upon power on and if the Check Sum of the running program does not
match the stored program, the unit will indicate this failure with a "CRC Error".
17. Once the software is loaded, all settings will need to be verified in the User and Set Up
screens.
18. Once all settings are correctly made and verified, enter back into the Set Up screens and
continue to the Load as Defaults screen and press the Load Defaults button.
118