Removing And Replacing The Front Chassis Panel - Cisco C22 Installation And Service Manual

Preparing for Server Component Installation

Removing and Replacing the Front Chassis Panel

To remove or replace the front chassis panel of the server, follow these steps:
Remove this panel only if you are instructed to do so in a procedure in this book.
Tip
Remove the front chassis panel (see
Step 1
a.
If you have a newer version of the server, the front chassis panel has no screws but instead lifts off after
Note
the top cover is removed. If you have an older version of the server that has screws on the front chassis
panel, continue with the following steps.
b.
c.
d.
Replace the front chassis panel:
Step 2
a.
Note
b.
If you have a newer version of the server, the front chassis panel has no screws but is instead held in
Note
place by spring-clips. If you have an older version of the server that has screws on the front chassis panel,
continue with the following steps.
c.
d.
Cisco UCS C22 Server Installation and Service Guide
3-8
Remove the top cover from the server as described in
Cover, page 3-7.
Use a #2 Phillips-head screwdriver to remove the two screws that secure the front chassis panel to
the chassis (see Figure 3-3).
Push the panel toward the server rear about one-half inch (1.27 cm), until its front flanges are free
from the front panel lip.
Lift the panel straight up from the server and set it aside.
Set the front chassis panel back in place, about one-half inch (1.27 cm) behind the front panel lip.
The flanges on the panel must slide under the front chassis lip.
Slide the front chassis panel toward the front chassis lip, sliding the flanges on the panel underneath
the front chassis lip.
Replace the two screws that secure the panel to the chassis (see
Replace the top cover to the server as described in
page 3-7.
Figure 3-3):
Removing and Replacing the Server Top
Removing and Replacing the Server Top Cover,
Chapter 3 Maintaining the Server
Figure 3-3).
OL-26646-01