Black & Decker WV3615 Manual page 5

As soon as the ambient
temperature has decreased, the
charger will resume operating.
The charger is intended for
indoor use only.
Read the manual carefully
before using the appliance.
Features
1. On/off switch
2. Release button
3. Dust bowl
4. Charging base
5. Charger
Fig. A
6. Crevice tool
7. Wet pick-up accessory
Installation
Fitting the charging base to the wall
(fig. B)
The charging base can be fitted to the
wall to provide a convenient storage and
charging point for the appliance.
Warning! Do not fit the charging base
directly over a mains supply. Ensure the
cord has a loop when the charger is
connected to the mains.
Assembly
Fitting the accessories (fig. A & C)
These models are supplied with the
following accessories:
- a crevice tool (6) for confined spaces
- a wet pick-up accessory (7) for wet
spills
To fit an accessory, proceed as follows:
Take the accessories from the
x
appliance.
Insert the appropriate accessory into
x
the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
ENGLISH
Use
Before first use, the battery must be
x
charged for at least 16 hours.
Place the appliance on the charging
x
base whenever it is not in use.
Charging the battery (fig. D)
Make sure that the appliance is
x
switched off. The battery will not be
charged with the on/off switch in the
on position.
Place the appliance on the charging
x
base as shown.
Plug in the charger. Switch on at the
x
mains.
Leave the appliance to charge for at
x
least 16 hours.
Whilst charging, the charger may become
warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
Warning! Do not charge the battery at
ambient temperatures below 4
above 40 C.
°
Switching on and off (fig. E)
To switch the appliance on, slide the
x
on/off switch (1) forward.
To switch the appliance off, slide the
x
on/off switch back.
Wet pick-up (fig. A)
Use the wet pick-up accessory (7) on
non-absorbent surfaces.
For best results when using this accessory,
hold the appliance at an angle of 45
pull it slowly towards you. On absorbent
surfaces, such as carpet, your appliance
will pick up wet spills better without the
accessory.
Emptying the dust bowl (fig. F & G)
Press the release button (2) and
x
remove the dust bowl (3).
Remove the filters (8 & 9).
x
Empty the dust bowl.
x
Refit the filters.
x
Refit the dust bowl onto the
x
appliance. Make sure the dust bowl
clicks into place.
C or
°
and
°
5