Table of Contents
Advertisement
Brought To You By Augusta Flint
8.
Make sure to keep hands and fingers away from the knives (16). Whenever
possible, use "pushsticks" and "pushblocks" (neither included) to feed the workpiece
into the Knives.
9.
keep all safety guards of the Rabbeting Jointer in place and in proper work-
ing order.
Never stand on the Rabbeting Jointer. Serious injury could occur if the unit is
10.
tipped or the Cutter is accidentally touched.
Make sure the workpiece is free from nails and any other foreign object which
11.
could break or otherwise damage the knives (16).
12.
Never start the Rabbeting Jointer under a load. Allow the tool to reach full speed
before feeding a workpiece into the Knives (16).
13.
Maintain control of the workpiece at all times. Never allow a workpiece to rest
on the moving Knives (16) without holding on to it.
WARNING! Some dust created by power sanding, sawing, grinding, drilling,
14.
and other construction activities, contains chemicals known [to the State of Califor-
nia] to cause cancer, birth defects or other reproductive harm. Some examples of
these chemicals are:
Lead from lead-based paints
Crystalline silica from bricks and cement or other masonry products
Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area,
and work with approved safety equipment, such as those dust masks that are spe-
cially designed to filter out microscopic particles. (California Health & Safety Code
§ 25249.5, et seq.)
1.
prior to performing service, maintenance, or cleaning procedures, always
make sure the Rabbeting Jointer's power Switch is in its "Off" position and
the power cord is disconnected from its electrical outlet.
2.
Do not alter or adjust any part of the Rabbeting Jointer that is assembled by
the manufacturer.
Always perform scheduled maintenance completely.
3.
for technical questions, please call 1-800-444-3353.
SKU 32966
MecHANIcAl pRecAuTIONS
Page 5
Advertisement
Table of Contents
