Table of Contents
Advertisement
Brought To You By Augusta Flint
1.
When unpacking, check to make sure all of the parts shown on the parts list
in this manual are included. If any parts are missing or broken, please call Harbor
Freight Tools at the number shown on the cover (and at the bottom of each page)
of this manual as soon as possible.
NOTe: During the following Steps, loosely finger tighten all fasteners until as-
1.
sembly is complete.
2.
Locate the Front Side Plate (15A) and Rear Side Plate (34A). Also, locate the two
Side Angle Plates (24A) and two Reinforce Plates (3A). (See Assy. Diagram.)
3.
Align the eight lower holes in the Front Side Plate (15A) and the eight lower holes
in the Rear Side Plate (34A) with the two holes located at each end of the two
Reinforcing Plates (3A) and with the two holes located at each end of the two Side
Angle Plates (24A). (See Assy. Diagram.)
for technical questions, please call 1-800-444-3353.
SKU 32966
SyMBOlOGy
fIGuRe c
uNpAckING
ASSeMBly INSTRucTIONS
TO ASSeMBle THe STAND
Page 8
Advertisement
Table of Contents
