Table of Contents
Advertisement
Brought To You By Augusta Flint
h.
Repeat the Steps above for the remaining two Knives (16).
Make sure to close the Left Protect Plate (28A). (See Assy. Diagram.)
i.
1.
The Fence Body (4) can be moved across the Front Table (2) and Rear Table (3) and
tilted 45 degrees left or right at any position on the Tables by means of the Handle
(72). (See figure H and Assy. Diagram.)
2.
To move the Fence Body (4) across the Front Table (2) and Rear Table (3), loosen
the Machine Screw (50). Move the Fence Body to the desired location. Then re-
tighten the Machine Screw. (See figure H and Assy. Diagram.)
3.
To tilt the Fence Body (4), loosen the Machine Screw (50). Use the Handle (72) to
tilt the Fence Body to the desired angle as indicated on the Tilt Angle Scale (41).
Then retighten the Machine Screw. NOTe: When tilting the Fence Body past the
Fixed Plate (47), the Stop Block (44) must be moved out of the way.
(See figure H and Assy. Diagram.)
4.
The Fence Segment (39) features positive stops at the most used fence positions of
90 degrees and 45 degrees, left and right. Check the Fence Body (4) with a square
to make sure the Fence is 90 degrees to the Front Table (2) and Rear Table (3). If
an adjustment is necessary:
a.
Loosen the Screw (48).
feNce BODy (4)
for technical questions, please call 1-800-444-3353.
SKU 32966
TO ADJuST THe feNce BODy
feNce SeGMeNT (39)
fIGuRe H
ScReW (48)
TIlT ANGle ScAle (41)
MAcHINe ScReW (50)
HANDle (72)
Page 14
Advertisement
Table of Contents
